We’d like to remind Forumites to please avoid political debate on the Forum.
This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Channel 4 and DVD recorder....
Encantador
Posts: 678 Forumite
in Techie Stuff
Can anyone advise on what might cause a panasonic DVD recorder not to be able to tune in Channel 4?
All the other channels are OK and when you plug the aerial lead directly into TV channel 4 is OK.
manual tuning the DVD recorder says `No Signal` whe you reach channel 4.
Strange....
Thanks in advance.
All the other channels are OK and when you plug the aerial lead directly into TV channel 4 is OK.
manual tuning the DVD recorder says `No Signal` whe you reach channel 4.
Strange....
Thanks in advance.
0
Comments
-
Encantador wrote:manual tuning the DVD recorder says `No Signal` whe you reach channel 4.
Either a poor tuner in your DVD recorder or it's clashing with it's UHF out channel.
Can you watch DVDs via the aerial lead i.e. without the SCART connected?0 -
Thanks for that.
The DVD worked OK until I stopped using it 12 months ago, it has now been put in a relatives house a couple of miles away.
I will try the lead tomorrow.
Is there anyway I can check if there is a clash while I am there?
Thanks again.0 -
Is ch4 OK on the TV when the DVD is cabled up & switched on?
If there was any conflict with frequecies I would expect it to show up.
Do you know which transmitter you're getting you TV signals from?0 -
There is no channel 4 on normal TV through the DVD recorder.
Plugging the aerial lead directly into TV is OK.
Aerial is on the wrekin or sutton coldfield.0 -
ch4 on Sutton Coldfield is ch50 & on Wrekin it's 29
Does it tell you anywhere in the literature what UHF channel it outputs to?0 -
I am pretty sure it was on No 29 when it said `Chanel 4 No Signal`
I cannot find the destructions for the machine which isn`t helping.
Does it make sense that the other 4 chanels would tune in automatically an noy C4???0 -
So it actually locks on to ch4 but can't decode the signal? odd!
It sounds like some sort of filtering is going on either because of a faulty modulator in the DVD or setup issues.
Without being able to play around with the the UHF output channel - its going to be difficult to get to the bottom of it.
A work around for now would be to split the aerial down-lead before it goes into the DVD & feed it seperatly to the TV.
This will of course mean that you can not record ch4 & you'll need to watch the DVD via the Scart or other A/V connection rather than the TVs UHF tuner0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 352.5K Banking & Borrowing
- 253.7K Reduce Debt & Boost Income
- 454.5K Spending & Discounts
- 245.5K Work, Benefits & Business
- 601.4K Mortgages, Homes & Bills
- 177.6K Life & Family
- 259.4K Travel & Transport
- 1.5M Hobbies & Leisure
- 16K Discuss & Feedback
- 37.7K Read-Only Boards