Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
DVD Burning Problem
polybear
Posts: 398
Forumite
in Techie Stuff
I tried to make a backup copy of my Packard Bell Master DVD using "Record
Now". Everything seemed to work fine, and the dvd-r appears to have a burnt area on it. However, when I click on the d:\ drive to check for the files there aren't any on the destination disk, and under properties both the "free" and "used" areas are both 0 bytes. I've done very little cd or dvd burning before - what stupid mistake have I done please? Thanks.
Polybear.
Now". Everything seemed to work fine, and the dvd-r appears to have a burnt area on it. However, when I click on the d:\ drive to check for the files there aren't any on the destination disk, and under properties both the "free" and "used" areas are both 0 bytes. I've done very little cd or dvd burning before - what stupid mistake have I done please? Thanks.
Polybear.
0
Comments
-
Maybe the Master DVD is protected against copying? I'm not sure how you would get round that legally.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179K Life & Family
- 263.9K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards