📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Plaster jointing tape showing

Options
2»

Comments

  • dave82_2
    dave82_2 Posts: 1,328 Forumite
    Cheers :-) fingers crossed they are just shining through while the plaster goes off!
  • chodjade
    chodjade Posts: 24 Forumite
    jason_s wrote: »
    If you can feel the scrim tape get him back to sort it, he hasn't put the skim on thick enough, and to be honest i would be a bit cautious as to if he has put the 2 coats on. Did you see him do any of the work?
    Thats just bloody shoddy workmanship and lazyness.

    I totally agree with this post and again the new post at bottom of page from the plumber you said also.
  • chodjade
    chodjade Posts: 24 Forumite
    misgrace wrote: »
    lol this is an old thread, I was the one that said it :D

    Wait till plaster goes off first, and if you still can see the material of the scrim, then knock up some filler, not the readymade stuff its a nightmare to sand down, spread the filler over where you can see the scrim, and feather the edges, meaning spread out the filler at the edges.
    When dry, get an old worn piece of sandpaper and gently sand the filler, if you still see any of the scrim, do it again, but it should cover it in the first fill.

    This ^^ also get some fine grade sand paper maybe start with rougher first until almost smooth with the plaster then use lighter grain sand paer to finish it nice an smooth an even.
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.1K Banking & Borrowing
  • 253.1K Reduce Debt & Boost Income
  • 453.6K Spending & Discounts
  • 244.1K Work, Benefits & Business
  • 599K Mortgages, Homes & Bills
  • 177K Life & Family
  • 257.4K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.