Hidden attatchments

Coolhandluke

What are my options for attatching a piece of timber board measuring 1/2" x 24" x 48" long to a wall if i want the attatchments to remain hidden?
i.e no screws in site.

flea72

Coolhandluke wrote: »

What are my options for attatching a piece of timber board measuring 1/2" x 24" x 48" long to a wall if i want the attatchments to remain hidden?
i.e no screws in site.

depends on what you are planning on using it for, as to where you could hide the screws

but, if you are going to paint the wood afterwards, i would countersink the screws, fill the holes, then paint over

Flea

brig001

Hidden fixings are available, but I don't know of anything that will work in 1/2 inch thickness. Minimum I have seen would work with 1 inch, like these: http://www.tuxfordfurniturehardware.co.uk/myshop/cat_123381-Concealed-Shelf-Brackets.html

HTH,
Bri.

KeithP

These flush mounts will do it.
With the added benefit of the panel being easily removable.
Alittle bit of careful measuring is needed though.

27col

Another idea would be to use a split batten I did this very successfully to fix a large headboard to the wall. Have a look here for the general idea.http://www.australiasigns.com.au/qsonline/lasercutting-16.html

Coolhandluke

Thanks for all your replys they were a great help.
Think i might try the flushmounts from Screwfix but will look for them locally rather than pay the P&P for just 1 item.

KeithP

Screwfix have branches these days... check here.

But I think I have seen these fittings in B&Q too.