Sky Remote volume buttons

hjb123

Having problems with our sky remote at the moment. All the buttons work except for the volume up button - volume down works fine

I rang Sky and their systems crashed and have to ring them back later so thought would see if anyone on here knows?

The TV is a Wharfedale L19T11W-C

Thanks

Kingsd316

Wharfedale is usually one of these:

065 or 574

hjb123

Kingsd316 wrote: »

Wharfedale is usually one of these:

065 or 574

thanks, Ill have another go with those codes but I think those were two of the three I had used

S3quence

Kingsd316 wrote: »

Wharfedale is usually one of these:

065 or 574

press TV
Hold down select and the red button for 2 seconds
enter the codes Kingsd316 has provided (may need to prefix with 0 so its 4 digits)

aylesby

We have the same problem with our Sony its a CRT 36 inch. Does anyone know their code.

S3quence

aylesby wrote: »

We have the same problem with our Sony its a CRT 36 inch. Does anyone know their code.

This site seems to list most...
http://www.hamradio-badarc.co.uk/skycodes2.htm

Kingsd316

S3quence wrote: »

press TV
(may need to prefix with 0 so its 4 digits)

I think some now have only 3 digits and are programmed slightly differently to the 4 digit codes:

To program using the 3 digit code.
1) Switch on the TV set
2) Press the TV button on the Sky Remote
3) Hold down the select and red buttons for 2-3 seconds until the LED blinks twice
4) Enter the 3 digit code
5) Press the select button to store
Press TV and any number to test,


4 digits is this:

To program using the 4 digit code
1) Switch on the TV set
2) Press the TV button on the Sky Remote
3) Hold down the select and red buttons for 2-3 seconds until the LED blinks twice
4) Press the TV button on the Sky Remote again
5) Enter the 4 digit code for your make of TV
6) The LED should blink twice, if not recheck the 4 digit code used and go back to 1
7) Press the standby button on the Sky Remote (The TV should go to standby)
8) Press select to store this setting
If the TV does not go into standby press the TV button then the standby button, then TV then standby, keep repeating this until successful. This will scan the codes used for a particular make of TV.

aylesby

This site seems to list most...
http://www.hamradio-badarc.co.uk/skycodes2.htm

It worked!!!!!