Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Bios factory reset when hardware added.
chunter
Posts: 2,039
Forumite
in Techie Stuff
I have a Gateway 1Mhz P3 which, whenever I add any internal bits ie pci card, memory, it resets the bios (back to original 2001 defaults) and in turn corrupts AVG.
Boots fine otherwise.
Anybody any ideas.
Boots fine otherwise.
Anybody any ideas.
0
Comments
-
The BIOS information is retained through the use of a battery (usually looking like a large watch battery) on the motherboard. My guess is the connection for that battery isn't too great which is why you lost the data when you're pulling and pushing hardware too and from the motherboard. It usually just has a metal contact holding it in on top, might be worth checking that out to see if it can be pushed further onto the battery.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards