Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Cuts on speaker cable caused by pet rabbit
joemardo1
Posts: 340 Forumite
in Techie Stuff
HI folks,
I have labtec 5.1 speakers that connect to mains (230-240v) via a supplied transformer.....after powered is reduced via supplied transformer to 14.4v--1000ma ....a few small cuts are in the light power cable which powers the unit, which I have wrapped black insulating tape around....also a few cuts on speaker cable which I have also insulated.....seems to be working fine now.....but I'm a bit worried in case its not safe....what do you think?
I have been told that as long as its on low powered voltage i.e after current has passed though the transformer and not on the main cable connecting to mains then I should be ok but appreciate your advice please.
Speakers are working fine now.
thanks
I have labtec 5.1 speakers that connect to mains (230-240v) via a supplied transformer.....after powered is reduced via supplied transformer to 14.4v--1000ma ....a few small cuts are in the light power cable which powers the unit, which I have wrapped black insulating tape around....also a few cuts on speaker cable which I have also insulated.....seems to be working fine now.....but I'm a bit worried in case its not safe....what do you think?
I have been told that as long as its on low powered voltage i.e after current has passed though the transformer and not on the main cable connecting to mains then I should be ok but appreciate your advice please.
Speakers are working fine now.
thanks
0
Comments
-
Ever seen Fatal Attraction ?
They should be ok but take to an electrical engineer if you are really worried.0 -
You can use a glue gun or epoxy resin as a more permanent repair on speaker cable. Don't try it on mains cable though!0
-
As long as it's not the cable between the mains and the transformer then bit of solder and insulation tape should do 'er (may be a slight reduction in sound qual if it is an issue to you - but prob not as pc speakers).
If it is between plug and transformer then bin and replace or see an electrician as bodge jobs with mains ac is NOT recommended.
If still not sure then supply with details of output voltage and current and power (usually printed on the transformer) and i'll have alook."Life? Life is nature's way of keeping meat fresh!"0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards