Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
New Brake Shoes/Cylinder Time?
When I've been sat on the brake for a while, and take my foot off and accelerate there is a high pitched noise coming from under the car. This noise stops after a reach 20mph + or if I then tap the brakes.
Also, for the first time yesterday I heard a clunk from the back when I took the hand brake off in the morning.
From previous experience on my 306, I believe this is my brake shoes/cylinders that are starting to go. Could anyone back me up on this theory? Usually, I source/buy the replacements myself and then get my independent garage to fit them but I've not had to buy much for my Leon yet, so any tips on what and where to buy replacements? (Obviously, I will get them to double check my theory before ordering new parts).
Also, for the first time yesterday I heard a clunk from the back when I took the hand brake off in the morning.
From previous experience on my 306, I believe this is my brake shoes/cylinders that are starting to go. Could anyone back me up on this theory? Usually, I source/buy the replacements myself and then get my independent garage to fit them but I've not had to buy much for my Leon yet, so any tips on what and where to buy replacements? (Obviously, I will get them to double check my theory before ordering new parts).
-highguyuk-
0
Comments
-
You're both right and wrong. It "could be". The clunk you heard is usually when the pads or shoes have stuck to the disc/drum when being parked overnight or longer when it's damp outside. Mine did yesterday when setting off first thing as it'd not been out for 3 days. That wouldn't be worrying me.
The high pitched noise could be some grit that's got in but then again it could also be wear however usually it continues past 20MPH. Brake dust build up also gives the same symptoms as can heat build up from prolonged braking. If it's only doing it when you've been riding the brakes, I'd be inclined to think it's heat or dust rather than wear.
The only guaranteed way to be sure is to whip the wheels off and look. Easiest way is to abuse Kwik-Fit. Take it in and ask them for a brake inspection. Get them to TELL YOU how low the pads are. A general rule of thumb is to advise to change the fronts at the next service when they get to 3mm. If there's 2-3mm, you've got a reasonable amount of time left before you replace them so no need to do it in the next couple of weeks.
With that in mind though, you need to get them checked soon in case they are worn as it will result in damage to the discs if they get down to metal.0 -
Thankyou for that advice, much appreciated.
My MOT is due December 20th, and even though my car has only done 5000 ish miles since it's last service I was planning to get it serviced as well (some other bits and pieces too). Considering bringing it all forward and just giving the car to the garage one day and getting them to do the lot so I'm without my car for one full day only.
Think my local Nationwide AutoCentre may be asked for a free brake inspection tomorrow. (I don't want to use Kwik Fit for anything!)-highguyuk-0 -
sounds like the brake shoes are sticking on a bit.
get the drums off it and put some copperslip on the shoe slides on the back plate....work permit granted!0 -
It's a Seat Leon - I'm more or less sure it has disk brakes all around.-highguyuk-0
-
possibly a siezing caliper then.It's a Seat Leon - I'm more or less sure it has disk brakes all around.
some vehicles with discs all round still have tiny little drums inside the rear dics with small shoes that serve as parking brake only.
the first shape of merc vito is one i know of that features this....work permit granted!0 -
I doubt it's a seized caliper at the rear - it'll be the pads that have stuck to the disc with the damp when the handbrake was let off. You just get a quick bang when you first move the car and that's it.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards