Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Help with set top box
Mrs_pbradley936
Posts: 14,573
Forumite
in Techie Stuff
I have a freeview set top box which has been working just fine for years. I switched it on this morning and was told that new channels had been added and that i should re-scan so I did and now it tells me that there is no signal and will not pick up any channels at all!
I have tried turning it off, unplugging it for a couple of hours and pulling out the aerial. Is there anything else I can do?
I have tried turning it off, unplugging it for a couple of hours and pulling out the aerial. Is there anything else I can do?
0
Comments
-
What make and model is it?0
-
It is a Daewoo Setpal0
-
It could be one of two issues - a recent signal change or a capacitor in the power supply section of this receiver which runs very hot and eventually fails.
You may have to purchase another0 -
This has happened to some of the "old" boxes as the update cannot be decoded by the box -- You could try contacting the manufacturer and explaining as I believe others have done and got replacements or discounted boxes -- Dave0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179K Life & Family
- 263.9K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards