We’d like to remind Forumites to please avoid political debate on the Forum.

This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.

📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
The Forum now has a brand new text editor, adding a bunch of handy features to use when creating posts. Read more in our how-to guide

Water in boiler cupboard?

I have a Halsted quattro gold combi boiler that is in a cupboard
in the bottom of the cupboard I keep pans/roasting trays etc. The pipes for boiler (where can top up pressure etc) are not boxed in.
taking a roasting tray out today I noticed that the pans at the back seem to have a small amount of water in them. I cannot see an actual leak from the pipes. Could it just be condensation?

Comments

  • Pssst
    Pssst Posts: 4,803 Forumite
    Part of the Furniture 1,000 Posts
    Unlikely though it depends on volume ! Saying that,if it was condensation then it would be apparent in other pans and in the cupboard generally.
    It is likely to be either

    Leakage from primary or secondary circuit
    Rainwater getting in via boiler flue or other opening
    pressure relief valve leakage

    I'd tend to think it was the first of the three

    Monitor the boiler system pressure guage and check if it has dropped or does drop over the next few weeks. Do take care to note the pressure when system is cold to ensure accuracy. How often if at all,do you have to top uo the pressure?
  • I topped it up yesterday from 1 to 1.5 (when cold, we don't have heating on at moment, only hot water, haven't topped up since march time) but then today it has shot up to 3 and is leaking from the overflow outside :confused:
    Very confused-how can it go up without me adding anything?
  • pressure in the system will rise with heat, 3 bar sounds excessive, therefore probably some fault is causing temp to rise too far...
    ..or....
    tap/s on filling loop not fully closed/faulty and allowing in water, you should be able to completely uncouple the filling connection if not allready done so.

    hope this helps.
    Please note, we've had to remove your signature because it was sh*te!
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 354.3K Banking & Borrowing
  • 254.4K Reduce Debt & Boost Income
  • 455.4K Spending & Discounts
  • 247.3K Work, Benefits & Business
  • 604K Mortgages, Homes & Bills
  • 178.4K Life & Family
  • 261.5K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16K Discuss & Feedback
  • 37.7K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.