📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Getting Distemper off Lathe and Plaster walls for skimming

2»

Comments

  • keystone
    keystone Posts: 10,916 Forumite
    kblufc7 wrote: »
    i did give 2 options remember the person is counting pennys
    How is that nasty if its the truth? Distemper is a chalk based product. You wet it - it comes off, there is very little adhesion to the wall. PVA will do nothing apart from provide a means to wet the distemper and when it dries it will not have sunk in but provide a really rather nice thin film sitting on the surface of something which isn't that well attached to the wall. Skim over that and down it all comes in due course. Although I didn't comment on your overboarding suggestion there is, IMHO, no merit whatsoever on boarding over a perfectly good piece of plaster just to skim over it again.

    Sorry if I offended you but I'm afraid your solution would not work in a month of Sundays.

    Cheers
    The difference between genius and stupidity is that genius has it's limits. - Einstein
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350.6K Banking & Borrowing
  • 253K Reduce Debt & Boost Income
  • 453.4K Spending & Discounts
  • 243.6K Work, Benefits & Business
  • 598.3K Mortgages, Homes & Bills
  • 176.7K Life & Family
  • 256.8K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.