We’d like to remind Forumites to please avoid political debate on the Forum.

This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.

📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Anyone having trouble refitting the condesnor in a hoover condenser/dryer?

Hi folks,


I have a Hoover condenser dryer about 18 mths old VTC 580 NC and just wondering if anyone else has had trouble refitting the large condenser part after cleaning? Not the water tray but the large condenser part at bottom.


The problem is, is that the plastic at back bottom of condenser goes below that slot that its supposed to fit into, probably over time has moulded into that shape, and no amount of pushing will put it back into place.


I have got it back in again, by taking a pair of pliers and bending that lower plastic bit upwards and now fits ok, will probably happen again though, so an on going problem.


Its just not a good design, otherwise the dryer is working ok, but wondering if anyone else had the same problem?


Thanks
John
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 352.3K Banking & Borrowing
  • 253.7K Reduce Debt & Boost Income
  • 454.4K Spending & Discounts
  • 245.3K Work, Benefits & Business
  • 601.1K Mortgages, Homes & Bills
  • 177.6K Life & Family
  • 259.2K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16K Discuss & Feedback
  • 37.7K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.