Uhome LFP 2400 Battery

Good Morning, 
I had a Solar system installed this year comprising Luxpower Hybrid Inverter LXP-3.6K, and 2 x Uhome LFP 2400 batteries. All working well. 
I obtained 2 new Uhome 2400 batteries and with the help of the technical support, and the manual for settings they were installed. Unfortunately the 2 new batteries never charged. I then noticed using the Uhome App that the batteries were at different charge states, so I set each individual battery to a Master, connected and charged. All charged bar 1 of the new ones. I can now get 3 batteries connected in Parallel and charging. The 4th battery is now set to Master and connected, the app shows a charge of 33w going to the battery, but after an overnight it's still just showing 1% SOC. The battery is online, and all the reports in Uhome app for it are OK. Only thing I've noticed is the working batteries are showing a voltage of 51.6v but the one not working shows 48.9%.
Would these batteries have a BCM that would have gone flat in storage? Any ideas on how to Kickstart it into life?

Mortgage - Free :j
Lloyds CC - £0 Paid Off
Santander CC - £0 Paid Off
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350.2K Banking & Borrowing
  • 252.8K Reduce Debt & Boost Income
  • 453.2K Spending & Discounts
  • 243.2K Work, Benefits & Business
  • 597.6K Mortgages, Homes & Bills
  • 176.6K Life & Family
  • 256.2K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.