My panasonic breadmaker blade

code-a-holic

Wll - it comes off during the process and is in the middle of the loaf. Didnt happen the first time i used it but has the 4 times since.
I have read through the manual and cant find refrence to it and have followed instructions to put it on. It says it should touch the bottom,.... but does not quite,
any ideas girls?!

Jayar

I had that problem too before I realised that a bit of old dough had stuck up the bit that goes over the spindle.
Yes I know ....... gross!

Whitefiver

code-a-holic wrote: »

girls?!

Cough, cough - not all breadmakers are girls!

As has been said, you need to remove the baked on bread around the spindle so that the paddle sits low in the pan. I do this by putting a small amount of cold water in (I believe you are not supposed to immerse the pan in water), and using a plastic brush to remove the caked on stuff. The water softens it in seconds. Make sure it is a plastic brush as you don't want to damage any of the non-stick surfaces.

Regards,

White.

code-a-holic

Firstly my sincerest apologies on the sexist girls bit! Not intentional, kind of rolled off the fingers! My husband loves breadmaking so silly mistake for me to make!

Thank you for that sugestion -will try it tonight, and pay attention to that bit in future

Whitefiver

code-a-holic wrote: »

Firstly my sincerest apologies on the sexist girls bit!

No problem - my reply was strictly tongue in cheek!

Hope it works for you.

Happy Christmas,

Regards,

White