Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Solar I boost thermostat
Swizz
Posts: 33
Forumite
We have ecodan heat pump with solar I boost diverting excess energy to heat the water. However, it is heating the water too hot..and I understand there is an independent thermostat on the immersion heater..but no idea where it is and how to adjust...
0
Comments
-
- Cut the power to your immersion heater.
- Take off the cover (typically round held on by a single nut). It will be on the side of your cylinder with wires going to it.
- Turn the little dial to a lower temperature.
- Replace the cover.
- Restore the power.
Reed1 -
Alternatively, get a plumber to fit a blending valve to the output from your cylinder so it doesn't matter how hot it gets. That's what I have.Reed0
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179K Life & Family
- 263.9K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards