Painting 'cardboard' wall

Hello! We're redecorating our entrance hall and while removing the wallpaper off one of the walls we noticed that it was some sort of cardboard instead of plaster. The idea is to paint this wall but I'm not sure how I'm going to do that now. Should I plaster it first (not sure if it's possible because of said cardboard)? Or should I remove the whole thing and then plaster it? I'm not sure what's actually underneath. Any help is appreciated!
i.imgur. com/nMl49H6.jpg

Comments

  • bris
    bris Posts: 10,548 Forumite
    Part of the Furniture 10,000 Posts Name Dropper
    A cardboard wall sounds like a bodged repair attempt at some point.


    Take it off and replace it with plasterboard.
  • Doozergirl
    Doozergirl Posts: 34,057 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    Is it hardboard? Only about half a centimetre thick?

    Take it off, replace with plasterboard and skim.

    Virtually our whole house was done with it. I've not seen it in a house before or since! It's no good as you can put your hand through it, even when plastered.
    Everything that is supposed to be in heaven is already here on earth.
  • johnny182
    johnny182 Posts: 39 Forumite
    Third Anniversary 10 Posts Name Dropper
    It looks like plasterboard over studs. Not sure why the previous owner didn't just plaster it but decided to wallpaper it instead. You're right, Doozergirl. I think I'll just replace it with plasterboard and skim it.
  • FreeBear
    FreeBear Posts: 17,839 Forumite
    Ninth Anniversary 10,000 Posts Name Dropper Photogenic
    http://i.imgur.com/nMl49H6.jpg - It might be an insulating wood fibre board, but you'd need to cut a hole in it to investigate. You will also need to see if it extends all the way up to the ceiling.

    Is this an external wall, or a stud construction thrown up round a cupboard ?
    Her courage will change the world.

    Treasure the moments that you have. Savour them for as long as you can for they will never come back again.
  • Tom99
    Tom99 Posts: 5,371 Forumite
    1,000 Posts Second Anniversary
    Drill a hole to see what it is. If its thick enough you could just use lining paper then paint.
  • molerat
    molerat Posts: 34,232 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    Fairly obviously plasterboard on studs. Is there a reason for it being bent ? What is on the other side ?
  • johnny182
    johnny182 Posts: 39 Forumite
    Third Anniversary 10 Posts Name Dropper
    I have no idea why they did it like that. Do you guys think lining paper would do the trick?
  • B_G_B
    B_G_B Posts: 502 Forumite
    Is it Tentest? Used quite a bit years ago.
  • bris
    bris Posts: 10,548 Forumite
    Part of the Furniture 10,000 Posts Name Dropper
    Just looks like plasterboard. If it's as solid as plasterboard then yes, just use a decent lining paper 1400 grade or higher at least and it will give a good finish.
  • lstar337
    lstar337 Posts: 3,443 Forumite
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Lots of places use plasterboard and just skim over the joints to neaten up.

    If you wallpaper over it nobody can tell, paint would take a few coats to cover it though. It makes the whole job cheaper as you don't need a plasterer.

    It's just cost-cutting.
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.7K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 452.9K Spending & Discounts
  • 242.6K Work, Benefits & Business
  • 619.4K Mortgages, Homes & Bills
  • 176.3K Life & Family
  • 255.5K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.