📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

NI firm: condensation on new double glazing

Options
should I be getting condensation on newly installed double glazing?
Surely not?

Comments

  • This may sound strange, where is the condensation? Is it on the inside, outside or in the middle of the glass?
    If its on the outside, that could be normal, I got some new windows recently that are gas filled, by design they'll keep all heat in so condensation can form on the outside.
    If its between the glass, it sounds like a design flaw and should be looked at.
    If its inside, that may not have anything to do with the new windows, did you used to get condensation on your old windows?
  • Belfastbelle
    Belfastbelle Posts: 367 Forumite
    Part of the Furniture 100 Posts Combo Breaker
    edited 19 October 2011 at 9:01AM
    Hi
    Thanks for the reply-
    It's in the inside and I did get condensation before ( one of the reasons for getting them replaced - although I don't think we discussed that/ or got any guarantee from the supplier)

    I thought double glazing didn't steam up - except in a bathroom perhaps ...
    Oops
  • BOBS
    BOBS Posts: 2,871 Forumite
    mornings like this mine has always steamed up - esp bedrooms - when i get up i put windows on latch and they soon clear.
    [FONT=verdana,arial,helvetica][/FONT]
  • suki1964
    suki1964 Posts: 14,313 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    Yep we get condensation on the bedroom windows as well these cold nights. Leave the vents open or best still open the window to the catch - will clear it
  • A.L.D.A
    A.L.D.A Posts: 522 Forumite
    Condensation forms when air is cooled to its dew point. The more moisture in the air, the higher the temperature at which condensation forms.

    The sort of activities that increase the moisture content of air are,
    drying clothes indoors, showers, cooking, gas room heaters, gas cookers, etc. All of these require ventilation. Gas room heaters and cooking produce a lot of water valour.

    If you have a defective damp proof course in the walls or damp proof membrane in the floor this will also add to the dampness.

    I have also seen people trapping damp into floors after building work by covering a floor with, say, vinyl before it is properly dried out.

    It is better to get condensation where you can see it than some of the places it can form. However if it is double glazing the condensation must be forming at relatively high temperatures. It suggests high humidity and/or inadequate ventilation.

    As a general rule always ventilate the cold space above insulation. You can get condensation forming in the roof space or in walls.
    [STRIKE]Less is more.[/STRIKE] No less is Less.
  • Thanks for all the advice folks- will look at the ventilation too
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.2K Banking & Borrowing
  • 253.2K Reduce Debt & Boost Income
  • 453.7K Spending & Discounts
  • 244.2K Work, Benefits & Business
  • 599.2K Mortgages, Homes & Bills
  • 177K Life & Family
  • 257.6K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.