repairing cast iron gutters and drainpipes
Options
Hatster
Posts: 97 Forumite
I'm hoping to repair a lot of rather elderly cast iron gutters and drainpipes - I can't see any actual holes, but they are quite rusty and in need of repainting.
Listed building, so replacing with plastic is not much of a solution here!
Is there any easy (or easier) way to go about renovating them? As far as I can see, they would need taking off the roof, getting the rust off, repainting and then putting back up again. Sounds like a fair amount of work...
Listed building, so replacing with plastic is not much of a solution here!
Is there any easy (or easier) way to go about renovating them? As far as I can see, they would need taking off the roof, getting the rust off, repainting and then putting back up again. Sounds like a fair amount of work...
0
Comments
-
I have cast iron drainpipes/guttering.
I have at present applied gutter sealant to prevent a leak. I will later clean gutters, remove any loose paint, and paint with Ronseal paint that can be applied to guttering and on top of rust (hammerite also do a paint that can be applied on rust). Then apply two coats of bitumen paint this is on inside of the guttering, the outside isnt too bad0 -
I have a 1953 house with the problem you describe. However, I also have a scaffold tower with wheels that reaches all the gutters. If you feel at the very back of the underside of them you are likely to encounter a crumbly layer, ie corrosion. I scuffed this off by hand and wire brushed where accessible. I googled 'Hammerite' and bought the cheapest black 5 litre version plus lots of 3" cheap brushes, as it's not worth cleaning them, the price they are. I painted the underside and topside using plenty at the back problem area. I removed the down pipes and found most were showing signs of a 'split' down the back. I filled these with 'gun and nails' smoothed off by hand and then painted with Hammerite. All the wooden spacer bobbins were rotten so I replaced them with plastic. The nails I replaced with galvanised 10mm bolts using plastic rawlplugs. Admittedly a lot of work but hopefully not repeated in the next 10 years +.0
This discussion has been closed.
Categories
- All Categories
- 343.3K Banking & Borrowing
- 250.1K Reduce Debt & Boost Income
- 449.7K Spending & Discounts
- 235.3K Work, Benefits & Business
- 608.1K Mortgages, Homes & Bills
- 173.1K Life & Family
- 248K Travel & Transport
- 1.5M Hobbies & Leisure
- 15.9K Discuss & Feedback
- 15.1K Coronavirus Support Boards