Forum Home » In my home (includes DIY) MoneySaving

pyronix enforcer v10 alarm system help - zones

New Post Advanced Search

Coronavirus: The latest from MSE


The MSE team is working extremely hard to keep the info we have about your travel rights, cancellation rights, sick pay (and more) up to date.
The official MSE guides: UPDATED MSE Coronavirus Guides

NEWSFLASH


New, free ‘Academoney’ course from MSE and the Open University launches
All the key areas of personal finance are covered, so that you can master your money decisions


pyronix enforcer v10 alarm system help - zones

wakkadaywakkaday Forumite
47 posts
Ninth Anniversary 10 Posts Combo Breaker
hey guys

i have done a reset of my alarm system (had front door changed which affected tamper on door and i made the mistake of resetting entire system)

so i am at step one and i am struggling to configure how it was before. i will try my best to give as much detail as possible.

This is the setting at the moment. And i have put in red, the bits i am struggling with and trying to configure


ZONE A/B (when leaving the home)

(KITCHEN MOTION SENSOR) - MODE 06 INTRUDER
(LOUNGE MOTION SENSOR ) - MODE 06 INTRUDER
(BEDROOM MOTION SENSOR) - MODE 06 INTRUDER
(UPSTAIRS LANDING) - MODE 6 INTRUDER

FRONT DOOR MC1MINI-WE - MODE FINAL EXIT/TIMED (SO THIS COUNTS DOWN FROM 25 SECONDS AND WHEN I CLOSE THE DOOR THE TONE STOPS)

However when i open the door, the system doesn't give me a countdown to enter my code to switch off the alarm? (it used to do this before)



ZONE B (NIGHT) - so i want downstairs active whilst we are sleeping upstairs

(KITCHEN MOTION SENSOR) - MODE 06 INTRUDER
LOUNGE MOTION SENSOR ) - MODE 06 INTRUDER
FRONT DOOR - WHAT MODE SHOULD THIS BE ON? i think i have set this as timed


Other Questions

I do have a bell box, but i need to get a ladder and learn the device again. What mode should be set too?

My backlight display on the device, times out so its blank after setting an alarm how do i make this visible at all times?

I want to add 2 more MC1MINI-WE to my set up in the near future

Upstairs Window
Back Conservatory Door

what mode do i need to put this on?


Other information

From my front door there is no motion sensor in the path of the Main Panel to trigger the alarm, as its near the door.

I wont be using my back door as an exit/entry route to arm/disarm the alarm


if you need any more information, please let me know, i would appreciate your assistance to get this working?
Sign In or Register to comment.

Quick links

Essential Money | Who & Where are you? | Work & Benefits | Household and travel | Shopping & Freebies | About MSE | The MoneySavers Arms | Covid-19 & Coronavirus Support